JuniperのJN0-660認定試験を受験する気があるのですか。この試験を受けた身の回りの人がきっと多くいるでしょう。これは非常に大切な試験で、試験に合格してJN0-660認証資格を取ると、あなたは多くのメリットを得られますから。では、他の人を頼んで試験に合格する対策を教えてもらったのですか。試験に準備する方法が色々ありますが、最も高効率なのは、きっと良いツールを利用することですね。ところで、あなたにとってどんなツールが良いと言えるのですか。もちろんJapanCertのJN0-660問題集です。
JapanCertがもっと早くJuniperのJN0-660認証試験に合格させるサイトで、JuniperのJN0-660認証試験についての問題集が市場にどんどん湧いてきます。JapanCertを選択したら、成功をとりましょう。
JapanCertはIT認定試験のJN0-660問題集を提供して皆さんを助けるウエブサイトです。JapanCertは先輩の経験を生かして暦年の試験の材料を編集することを通して、最高のJN0-660問題集を作成しました。問題集に含まれているものは実際試験の問題を全部カバーすることができますから、あなたが一回で成功することを保証できます。
試験番号：JN0-660問題集
試験科目：Juniper 「Service Provider Routing and Switching, Professional (JNCIP-SP)」
最近更新時間：2014-02-10
問題と解答：248
JapanCertが提供する真実と全面的なJuniper認証試験について資料で100%で君の試験に合格させてまたあなたに1年無料のサービスを更新し、今はJapanCertのインターネットで無料のJuniperのJN0-660認証試験問題集のソフトウェアがダウンロード することができます。
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://www.japancert.com/JN0-660.html
NO.1 Click the Exhibit button.
Based on the configuration in the exhibit, which statement is correct?
A. The 172.20.20.0/24 route is installed in the inet.0 table with the next hop of the LSP.
B. The 172.20.20.0/24 route is installed in the mpls.0 table with the next hop of the LSP.
C. The 172.20.20.0/24 route is installed in the inet.3 table with the next hop of the LSP.
D. The 172.20.20.0/24 route is installed in the inet6.3 table with the next hop of the LSP.
Answer: C
Juniper JN0-660 JN0-660
NO.2 Which two statements are true about OSPFv3? (Choose two.)
A. OSPFv3 uses a 32-bit router ID to uniquely identify a node in the network.
B. OSPFv3 uses a 128-bit router ID to uniquely identify a node in the network.
C. OSPFv3 routes are always preferred over OSPFv2 routes for all traffic.
D. OSPFv3 and OSPFv2 can be configured at the same time.
Answer: A, D
Juniper認定試験 JN0-660認定試験 JN0-660認定資格 JN0-660
NO.3 Click the Exhibit button.
In the exhibit, ISP A is charged a higher rate for traffic sent to R2. You are asked to lower costs for ISP A
by configuring R1 to send traffic to R3 whenever possible.
What are two ways to do this? (Choose two.)
A. set protocols bgp group isp-b neighbor 192.0.2.6 local-preference 120
B. set protocols bgp group isp-b neighbor 192.0.2.6 local-preference 80
C. set protocols bgp group isp-b neighbor 192.0.2.10 local-preference 120
D. set protocols bgp group isp-b neighbor 192.0.2.10 local-preference 80
Answer: B, C
Juniper JN0-660認定資格 JN0-660練習問題 JN0-660 JN0-660認定試験
NO.4 Click the Exhibit button.
As shown in the exhibit, you have an adaptive LSP that requires 85 Mbps. The LSP is configured with a
primary path and a secondary path in standby mode. All connections in the MPLS network are Fast
Ethernet. Which statement is correct?
A. The primary and secondary paths are in an up state and operational.
B. The primary and secondary paths are in a down state and not operational.
C. The secondary path is in a down state and not operational.
D. The primary path is in a down state and not operational.
Answer: A
Juniper練習問題 JN0-660 JN0-660 JN0-660 JN0-660過去問
NO.5 Click the Exhibit button.
Referring to the exhibit, which type of traffic protection mechanism is used for the LSP?
A. fast-reroute
B. link-protection
C. node-link-protection
D. secondary
Answer: B
Juniper JN0-660認定資格 JN0-660認定試験
NO.6 Your multicast receivers are indirectly connected to an MX Series router. The receivers need to join
multicast group 224.2.2.2. What must be configured in IGMP to receive report messages from receivers
that are multiple hops away?
A. By default, IGMP accepts report messages from indirectly connected receivers.
B. Promiscuous mode must be enabled in IGMP.
C. Promiscuous mode must be disabled in IGMP.
D. DVMRP protocol must be configured.
Answer: B
Juniper過去問 JN0-660 JN0-660認定資格 JN0-660認定資格 JN0-660参考書
NO.7 Click the Exhibit button.
Given the drop profile in the exhibit, what is the drop probability when the buffer reaches 90% full?
A. 60%
B. 70%
C. 85%
D. 90%
Answer: B
Juniper JN0-660 JN0-660 JN0-660過去問 JN0-660
NO.8 You manage an MPLS network where the PE devices consist of multiple vendors.
You are asked to conceal the MPLS topology for all LSPs.
Which global configuration parameter will accomplish this?
A. Configure no-decrement-ttl on the ingress router only.
B. Configure no-propagate-ttl on the ingress router only.
C. Configure no-decrement-ttl on all routers within the MPLS network.
D. Configure no-propagate-ttl on all routers within the MPLS network.
Answer: D
Juniper JN0-660参考書 JN0-660練習問題 JN0-660 JN0-660問題集
NO.9 Click the Exhibit button.
On your MX Series router, traffic using the critical scheduler is out of profile. All other data is currently in
profile. Referring to the exhibit, which statement is correct?
A. The critical queue is serviced before the less-critical queue.
B. The critical queue is serviced after the left-over queue.
C. The critical queue is serviced before the data queue.
D. The critical queue is serviced before the voice queue.
Answer: B
Juniper練習問題 JN0-660過去問 JN0-660参考書 JN0-660認定証
NO.10 You are the administrator for a network that uses IBGP. As the network grows, you must examine
options to support increased scale.
Which two scaling options should you consider? (Choose two.)
A. route reflection
B. areas
C. zones
D. confederations
Answer: B, C
Juniper参考書 JN0-660認定試験 JN0-660 JN0-660
NO.11 In which two ways does VPLS populate the MAC table? (Choose two.)
A. dynamically using BGP
B. dynamically using the source MAC address on received frames
C. dynamically using LDP
D. statically using CLI
Answer: B, D
Juniper JN0-660 JN0-660
NO.12 Click the Exhibit button.
All routers in the exhibit are running IS-IS level 2 routing. The wide-metrics-only parameter is configured
on all routers. Which metric does R1 see for the path to R4?
A. 136
B. 138
C. 310
D. 320
Answer: D
Juniper JN0-660問題集 JN0-660問題集 JN0-660問題集 JN0-660
NO.13 Which operational mode command displays the number of configured forwarding classes?
A. show interfaces queue ge-1/0/0
B. show interfaces terse
C. show class-of-service interface
D. show forwarding classes
Answer: A
Juniper問題集 JN0-660認定試験 JN0-660
NO.14 Click the Exhibit button.
You are asked to configure an OSPF network based on the topology shown in the exhibit. You must keep
the link-state database in Area 1 as small as possible. What will accomplish this?
A. Area 0 should be configured as a stub area so that it will not announce routes into Area 1.
B. Area 1 should be configured as an NSSA to limit the size of the link-state database.
C. Area 1 should be configured as a stub area with no-summaries to limit the size of the link-state
database.
D. Area 0 should be configured with a virtual link to R4 to limit the size of the Area 1 link-state database.
Answer: C
Juniper JN0-660 JN0-660練習問題 JN0-660練習問題 JN0-660
NO.15 Click the Exhibit button.
All networks shown in the exhibit contain more than one BGP speaking router. You operate ISP A.
You must ensure that customer Y sends their traffic to you over the directly connected link but customer Y
is not used for transit into your network. What do you do to accomplish this? A. Advertise routes to
customer Y with the well-known no-transit community.
B. Advertise routes to customer X with the well-known no-advertise community.
C. Advertise routes to customer Y with the well-known no-export community.
D. Advertise routes to customer X with the well-known as-transit community.
Answer: C
Juniper参考書 JN0-660 JN0-660 JN0-660 JN0-660認定資格 JN0-660
NO.16 Your are the administrator for a network that uses IS-IS as its IGP. As the network grows, you find that
the protocol's default capabilities for setting metrics is limiting your options. Which feature can you
implement to provide a larger range of metric configuration capabilities?
A. extended metrics
B. wide metrics
C. expanded metrics
D. full metrics
Answer: D
Juniper JN0-660練習問題 JN0-660認定試験 JN0-660認定証
NO.17 Which CoS feature supports per-VLAN queuing and scheduling?
A. multilevel scheduling
B. hierarchical scheduling
C. tagged queuing
D. per-instance queuing
Answer: C
Juniper問題集 JN0-660 JN0-660
NO.18 Click the Exhibit button.
Referring to the exhibit, which MPLS feature was used to make the LSP the preferred path for internal
routes.?
A. traffic engineering bgp-igp
B. traffic engineering shortcuts
C. traffic engineering mpls-forwarding
D. install active
Answer: C
Juniper JN0-660 JN0-660 JN0-660認証試験 JN0-660
NO.19 Click the Exhibit button.
In the exhibit, Area 1 is a not-so-stubby area.
Three networks are redistributed into Area 1 on R2.
You must summarize the redistributed network addresses in Area 1 so that only one network prefix is
re-advertised into Area 0. You must also summarize the loopback addresses of R1 and R2 into a single
address in Area 0.Which configuration sample on R3 and R5 will complete this task?
A. Option A
B. Option B
C. Option C
D. Option D
Answer: C
Juniper参考書 JN0-660 JN0-660練習問題 JN0-660認定証 JN0-660認定資格
NO.20 You are provisioning a new customer for access to your Layer 3 VPN. The customer is using
172.16.35.0/24 as their internal IP address space, which is also being used by an existing Layer 3 VPN
customer. The two customers share many PE routers in common across your network. Which mechanism
allows these duplicate addresses to exist in your network?
A. route origin
B. route target
C. route refresh
D. route distinguisher
Answer: D
Juniper問題集 JN0-660認定試験 JN0-660 JN0-660
JapanCertは最新の70-414問題集と高品質の70-464問題と回答を提供します。JapanCertの1Z0-511 VCEテストエンジンとIIA-CGAP試験ガイドはあなたが一回で試験に合格するのを助けることができます。高品質のCAT-340 PDFトレーニング教材は、あなたがより迅速かつ簡単に試験に合格することを100％保証します。試験に合格して認証資格を取るのはそのような簡単なことです。
没有评论:
发表评论