一つの試験だけでは多くの時間を無駄にする必要がありません。350-021認定試験が大変難しいと感じて、多くの時間を取らなければならないとしたら、ツールとしてJapanCertの350-021問題集を利用したほうがいいです。この問題集はあなたに時間を節約させることができますから。もっと重要なのは、この問題集はあなたが試験に合格することを保証できますから。この問題集よりもっと良いツールは何一つありません。試験の準備をするのにたくさんの時間を無駄にするより、そんな時間を利用してもっと有意義なことをしたほうがいいです。ですから、はやくJapanCertのサイトに行ってもっと多くの情報を読みましょう。この素晴らしきチャンスを逃したらきっと後悔しますよ。
Ciscoの350-021の認定試験は当面いろいろな認証試験で最も価値がある試験の一つです。最近の数十年間で、コンピュータ科学の教育は世界各地の数多くの注目を得られています。Ciscoの350-021の認定試験はIT情報技術領域の欠くことができない一部ですから、IT領域の人々はこの試験認証に合格することを通じて自分自身の知識を増加して、他の分野で突破します。JapanCertのCiscoの350-021認定試験の問題と解答はそういう人たちのニーズを答えるために研究した成果です。この試験に合格することがたやすいことではないですから、適切なショートカットを選択するのは成功することの必要です。JapanCertはあなたの成功を助けるために存在しているのですから、JapanCertを選ぶということは成功を選ぶのことと等しいです。JapanCertが提供した問題と解答はIT領域のエリートたちが研究と実践を通じて開発されて、十年間過ぎのIT認証経験を持っています。
IT認定試験を受ける受験生はほとんど仕事をしている人です。試験に受かるために大量の時間とトレーニング費用を費やした受験生がたくさんいます。ここで我々は良い学習資料のウェブサイトをお勧めします。JapanCertというサイトです。JapanCertの Ciscoの350-021試験資料を利用したら、時間を節約することができるようになります。我々はあなたに向いて適当の資料を選びます。しかも、サイトでテストデータの一部は無料です。もっと重要のことは、リアルな模擬練習はあなたがCiscoの350-021試験に受かることに大きな助けになれます。JapanCert のCiscoの350-021試験資料はあなたに時間を節約させることができるだけではなく、あなたに首尾よく試験に合格させることもできますから、JapanCertを選ばない理由はないです。
JapanCertはもっぱらITプロ認証試験に関する知識を提供するのサイトで、ほかのサイト使った人はJapanCertが最高の知識源サイトと比較しますた。JapanCertの商品はとても頼もしい試験の練習問題と解答は非常に正確でございます。
試験番号：350-021問題集
試験科目：Cisco 「CCIE SP Cable Qualification Exam」
最近更新時間：2013-10-23
問題と解答：399
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://www.japancert.com/350-021.html
NO.1 A router is set to boot from flash, but cannot find boot commands in the configuration. Also, valid files
do not exist in the default flash device. The router will:
A. Boot from ROM, since there are no valid sources
B. Try to boot from the network, using a default filename
C. Terminate the boot process with an error message
D. Try to boot from the network, then boot from ROM as a backup
Answer: D
Cisco認定資格 350-021 350-021 350-021
NO.2 What is NOT an ATM class of service?
A. CBR
B. VBR-t
C. ABR
D. UBR
E. CAR
Answer: E
Cisco認証試験 350-021過去問 350-021練習問題 350-021認定試験 350-021参考書
NO.3 Given a PAL HFC and 8 MHz channel lineup in the downstream, is it possible to utilize 6 MHz DOCSIS
cable modems and signals on the network?
A. No, only 8 MHz channel spacing is available for Downstream data signals
B. Yes, as long as the 6 MHz DOCSIS signal is within a valid 8 MHz channel
C. Yes, as long as the DOCSIS signal is upconverted through a PAL upconverter
D. No, DOCSIS cannot be mixed with EuroDOCSIS in the Donwstream
E. DOCSIS must be used only in an EIA-542 channel plans
Answer: B
Cisco練習問題 350-021 350-021 350-021 350-021認定試験
NO.4 Which are HFC cable television forward path networks aligned to provide? (multiple answer)
A. For asymmetrical gain since the downstream and upstream bandwidths are also asymmetrical
B. For unity gain with a fixed input level and varying output levels adjusted by the selection of a fixed
value attenuator and equalizer at the output stage in each of the forward amplifiers in the network
C. For unity gain with a fixed output level and varying input levels adjusted by the selection of a fixed
value attenuator & equalizer at the input stage of each of the forward amplifiers in the network
D. It is not necessary to align the forward path amplifiers since the CMTS will automatically compensate
for forward path gain discrepancies.
E. For unity gain and are level compensated by automatic gain and slope control systems utilizing RF pilot
reference carriers
Answer: CE
Cisco認定試験 350-021 350-021 350-021 350-021問題集
NO.5 The name of the DOCSIS config file to download will be offered to the cable modem in what DHCP
field?
A. giaddr
B. config-filename
C. packet-filename
D. siaddr
Answer: C
Cisco 350-021認定資格 350-021問題集 350-021
NO.6 There are two different headends with two different frequencies available sharing the same plant.
There is a -10dB cable loss to the second active in the cascade. What is the required pad for balancing
A. A 0 pad
B. A 1 pad
C. A 2 pad
D. A 3 pad
E. A 4 pad
F. A 5 pad
Answer: F
Cisco 350-021 350-021 350-021
NO.7 Cisco recommends the use of a headend-grade coaxial cable or a quad-shield coaxial cable with a
minimum of 60% + 40% braid and double foil insulation to connect the cable modem cards to the HFC
network. The center conductor must be straight and extend 1/8 inch (3.2 mm) beyond the end of the
connector, and the connector should be securely crimped to the cable. Select three recommended cable
types that can be used to connect the Cisco uBR7200 series universal broadband routers: (multiple
answer)
A. RG 58
B. RG 59
C. RG 59/U
D. RG 6
E. RG 7
Answer: BCD
Cisco 350-021 350-021練習問題
NO.8 What effect will this configuration command have?
line vty 0 4
no password vtypassword
A. All telnet connections to the router will be denied.
B. Only one telnet connection at the router will be allowed at a time.
C. Virtual terminal sessions will not be able to enter enable mode.
D. Virtual terminal sessions will not be asked a user-level password.
E. It will have no effect.
Answer: A
Cisco認定証 350-021過去問 350-021 350-021問題集 350-021過去問
NO.9 Upon deleting an IOS image file from flash, an execution of show flash shows the file still in flash, with
a 'D' preceding it (as shown in the exhibit). What step must be taken in order to remove the file
completely?
A. Erase the file from flash
B. Format the flash device
C. Replace the flash card - it is defective
D. Execute a squeeze command on the flash device
Answer: D
Cisco 350-021 350-021問題集
NO.10 What describes a technique, used to encapsulate voice (NOT data) over ATM?
A. RFC 1483
B. LANE
C. AAL-1
D. RFC 1577
Answer: C
Cisco 350-021参考書 350-021
NO.11 What is the purpose of rate decoupling for ATM transmission?
A. It provides transparency between SONET and SDH.
B. It converts higher-speed DS3/E3 to lower-speed optical rates.
C. It processess the packing and unpacking of frames into 53-octet cells.
D. It allows lower-speed traffic on an ATM facility without causing traffic gaps.
Answer: D
Cisco問題集 350-021 350-021
NO.12 Unity gain is being used for alignment. The first amplifier from the node has 25 dB of gain and is 2000
feet away with cable loss of 1 dB per 100 feet. The node has an output of 35 dBmV at 55.25 MHz. What is
the input at the amplifier?
A. 13dBmV
B. 3dBmV
C. 15dBmV
D. 27dBmV
Answer: C
Cisco 350-021 350-021認証試験 350-021認定試験
NO.13 For an OC-48 signal (2.5Gb/s), what is the BER (bit error rate) if there is 1 bit error every four days?
A. 10E-12
B. 10E-13
C. 10E-14
D. 10E-15
E. 10E-16
Answer: D
Cisco 350-021 350-021認定試験 350-021 350-021認定試験
NO.14 For communications systems what describes the over-all health of the system?
A. Bit-Error-Rate (BER)
B. Synchronous Optical NETwork (SONET)
C. Optical Signal to Noise Ratio (OSNR)
D. None of the above
Answer: A
Cisco 350-021認定試験 350-021
NO.15 If there are two different headends with two different frequencies available sharing the same plant, what
frequency will the two groups of cable modems, which are brand new, and have never been on-line, lock
on?
A. They will lock on the frequency configured on the linecard.
B. They will lock on the frequency configured on the upconverter.
C. They will lock on the first frequency they find.
D. They will lock on the lowest frequency.
E. They will lock on the last frequency remembered in ram.
Answer: C
Cisco 350-021 350-021問題集
NO.16 HFC cable television return path networks are aligned to provide: (multiple answer)
A. Asymmetrical gain since the downstream and upstream bandwidths are also asymmetrical
B. Unity gain with a fixed input level and varying output levels adjusted by the selection of a fixed value
attenuator and equalizer at the output stage in each of the return amplifiers in the network
C. Unity gain with a fixed output level and varying input levels adjusted by the selection of a fixed value
attenuator and equalizer at the input stage of each of the return amplifiers in the network
D. Cable modems the ability to power range comfortably within their output power dynamic range
E. It is not necessary to align the return path amplifiers since the CMTS will automatically adjust the cable
modem transmit power levels.
Answer: BD
Cisco 350-021 350-021 350-021
NO.17 A network administrator is using debug commands to check the performance of a network. What steps
can the administrator take to ensure that the "debug" will not require too much CPU, or at least that she
will not have to reboot the router to disable debug? (multiple answer)
A. Make the debug command as specific as possible
B. Use the max-time parameter of the debug command
C. In configuration mode, enter scheduler interval 15
D. Configure a loopback to channel debug traffic
Answer: AC
Cisco過去問 350-021 350-021 350-021
NO.18 A DOCSIS 2-way data system is being designedto limit upstream traffic. Unknown modems should be
kept from using precious Upstream bandwidth. Given these requirements, it should beensured that the
DOCSIS configuration file has what set?
A. Vendor-specific information field
B. Max-cpe should be set to 1
C. CMTS authentication field should be set
D. Network Access should be set to 0
E. Downstream frequency should be set above 450 MHz
Answer: D
Cisco認証試験 350-021 350-021認定試験
NO.19 Every time a typing mistake is made at the exec prompt of a router, the message from the router
indicates a lookup is being performed. Also, there is a waiting period of several seconds before the next
command can be typed. Can this behavior be changed?
A. No, this is a built in feature of Cisco IOS? software.
B. Yes, use the no ip domain-lookup command.
C. Yes, use the no ip helper-address command.
D. Yes, use the no ip multicast helper-map command.
E. Yes, use the no exec lookup command.
Answer: B
Cisco過去問 350-021 350-021
NO.20 In a cable HFC plant, which devices are modulators? (multiple answer)
A. CMTS line card
B. Upconverter
C. Diplex filter
D. Set top box
E. Fiber node
Answer: AD
Cisco 350-021認定試験 350-021練習問題 350-021 350-021 350-021
JapanCertは最新のHP2-H29問題集と高品質のBAS-002問題と回答を提供します。JapanCertの70-465 VCEテストエンジンと00M-503試験ガイドはあなたが一回で試験に合格するのを助けることができます。高品質の70-462 PDFトレーニング教材は、あなたがより迅速かつ簡単に試験に合格することを100％保証します。試験に合格して認証資格を取るのはそのような簡単なことです。
没有评论:
发表评论